exothermicity是什么意思 exothermicity怎么读
英式：[eksʌθɜ:'mɪsɪtɪ]
美式：[eksʌθɜ:'mɪsɪtɪ]
exothermicity单词基本解析：
放热性exothermicity变化用词：
exothermicity英英释义：
exothermicity中文词源：
exothermicity用法和例句：
exothermicity
DSC was used to measure the exotherm during curing of the blend resin system.
3．通过DSC测试了共混树脂的固化放热性能，并比较了共混树脂在两类不同室温固化体系下的放热性能。
Exothermicity and alternating internal stress are the key factors which make partial discharge channels keep on growing.
充电电压和放电反峰系数的增大使发热和介质内应力加剧，可以使寿命缩短90%以上。
Keywords coal spontaneous combustion;coal natural fire time;oxygen consumption speed;exothermicity;limit parameters;
关键词煤自燃;自然发火期;耗氧速度;放热强度;极限参数;
Because many roasting systems exhibit thermal hysterysis using simple temperature regulating schemes, care must be taken not to allow the coffee mass to exotherm.
因为许多烘焙系统使用简单的温度调节机理，这些系统会表现出热滞后效应，所以一定要很小心，不要让咖啡放热。
curing exotherm
固化放热
The composition was determined and its physical and chemical properties,processability,curing reaction exothermicity and heat resistance were examined.
实验确定了灌封胶的配比,并考核了胶的理化性能、工艺性能、热反应性能、耐高温性能等。
All fillers lowered the maximum exotherm.
所有填料都降低放热效应。
Keywords coal spontaneous combustion;exothermicity;fire prediction;oxygen consumption speed;
煤自燃;放热强度;火灾预测;耗氧速度;
Keywords coal spontaneous combustion;characteristic parameters;simulation experiment;exothermicity;visualization.;
煤自燃;特性参数;实验模拟;放热强度;可视化;
Keywords coal spontaneous combustion;oxygen consumption speed;exothermicity;
煤自燃;耗氧速度;放热强度;
STUDY ON THE EXOTHERM IN CURING PROCFSS OF EPOXY RESIN
环氧浇铸体固化过程放热研究
Exotherm termil
百菌清
The DSC thermograms with exothermicity of the condensation reaction and endothermicity of small molecules evaporation show wide and smooth peaks.
结果表明,羟甲基参与固化反应,生成亚甲基或醚键。
polymerization exotherm
聚合放热
the use of filler decreased the exotherm of diamine cure,but incr...
胺固化的冲击强度较高,加入填料可提高拉伸强度。
And by compare the exotherm of the resin cured by two kind of curing system at room temperature we can found that the resin we synthesized has lower exotherm, especially when use BPO as initiator.4.
证明该树脂体系具有较低的固化放热峰，而且表明以过氧化苯甲酰作为引发剂具有更低的放热峰温度。
12.Excessive dispersion time at high speed causes temperature build-up which can result in marked viscosity reduction, with severe splashing at least, and the possibility of a dangerous exotherm.
过多的分散时间会升高温度，粘度降低，导致漆料溅出，可能的放热危险。
The DTA curve of the fine clay fraction exhibits a major exotherm near 340℃.
这种细粒土级分的DTA曲线接近340℃处有一个很大的放热峰。